Advertisement
SWITCHLOCK
See Figure &
The switch trigger can be locked in the OFF position. This
feature can be used to prevent the possibility of accidental
starting when not in use. To lock switch trigger, place the
direction of rotation selector in center position
SELECTOR
CENTERPOSITION
'_
_
REVERSE
G
FORWARD
SWITCH
TRIGGER
Fig, 6
,_
WARNING:
Battery tools are always in operating
condition
Therefore, switch should always be locked
when not in use or carrying at your side
REVERSIBLE
See Figure 6.
This toot has the feature of being reversible. The direction
of rotation is controlled by a selector located above the
switch trigger
With the drill held in normal operating
position, the direction of rotation selector should be
positioned to the left of the switch for drilling. The drilting
direction is reversed when the selector is to the right of
the switch. When the selector is in center position, the
switch trigger is locked.
,_
CAUTION:
To prevent gear damage, afways allow
chuck to come to a complete stop before changing
the direction of rotation or the two-speed gear train
(hi-lo)
To stop, release switch trigger and allow the chuck to come
to a complete stop
KEYLESS
CHUCK
See Figure Z
Your drill has a keyless chuck As the name impties, you can
hand tighten or release drill bits in the chuck jaws.. Grasp
and hold the collar of the chuck with one hand Rotate chuck
body with your other hand The arrows on the chuck indicate
which direction to rotate the chuck body in order to LOCK
(tighten) or UNLOCK (release) the chuck jaws
DRILL BIT
UNLOCK
(RELEASE)
CHUCK BODY
LOCK
(TIGHTEN)
/
CHUCKCOLLAR
Fig 7
A
WARNING:
Do not hold chuck body with one hand
and use power of the drill to tighten chuck jaws on
drill bit Chuck body could slip in your hand or your
hand could slip and come in contact with rotating drill
bit. This could cause an accident resulting in serious
personal injury,
10
Advertisement
