Advertisement
,_
WARNING:
Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible sedous injury.
CHARGING YOUR SCREWDRIVER
This tool has been shipped in a low charge condition
to
prevent possible problems. Therefore, you should charge it
overnight prior to use.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (driving screws followed
by recharging) for them to become fully charged.
If the charger
does not charge your screwdriver
under
normal
circumstances,
return both the screwdriver
and
charger to your nearest Sears Service Center for electrical
check.
TO CHARGE
•
Insert charger plug into input jack making sure they
are properly connected.
•
Charger can be used with normal household
voltage of 120 volts, 60 Hz, AC only,
•
Connect charger to power supply.
•
After normal usage, a minimum of 3-5 hours of charg-
ing time is required to fully recharge batteries.
Note: If batteries are fully discharged,
10 to 12 hours
of charging time is required to fully recharge them.
•
Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
COLLET
The collet on your screwdriver has been designed to accept
1/4 in. hex bits. See Figure 3
TO INSERT
BIT
See Figure 3
Insert bit into co]let as far as possible.
Note: One bit is packed with your screwdriver.
CHARGER
CHARGERPLUG
INPUT JACK
Fig. ,_
Advertisement
