Table of Contents
Advertisement
h.
Pull on the nylon line to change the spool from the
lockedposition to the operating position. Figure 24.
Obtain correct line length by pressing tap button and
pulling on nylon line again.
NOTE: Approximately 2 inches of line can be
advanced each time the tap button is pressed.
Figure 24.
USE ONLY SEARS/CRAFTSMAN
®
REPLACEMENT
PARTS
2. CUTTING
LINE REPAIR
• If the cutting line breaks off or backs up in the
cutting head, follow "Cutting Line Replacement",
omittingstep "e".
3. SPOOL REPLACEMENT
a Replace the spool when: The square corners of
the drive lugs are rounded off, reduced in size, or
broken off. Figure 25.
b. To replace
the spool,
follow "Cutting
Line
Replacement" (page 12).
4. LINE LIMITER MAINTENANCE
• The line limiter is the metal blade found on the
splash deflector.
_-Theline-limiter
must be kept sharp to:
-- allow fast, easy cut-off.
avoid excessive wear to the cutting head.
•• To sharpen:
Use a fiat file and file from the outside toward the
inside of the line limiter,Figure 26.
in
Approximately2 inches
of line canbe advanced
eachtime the Tap Button
is pressed.
TAP BUTTON
Figure 24
NORMAL SPOOL
i
ii
Figure 25
WORN SPOOL
Figure 26
NOTES
13
Advertisement
Table of Contents
