Advertisement
BA SiC SHAPING; O PERATION
S
cutter would
have to be turned over.
2i :Always
remember
(when
mounting
the cutter)
that the
cutting
edge of cutter
must
lead into
the direction
of
rotation;
Instructions:_:for
: reversing
the
motor
rotation
are
normally
:foUnd On the motor
name plate,
or electrical
cover plate.
Make sure the plug has been removed
from
electrical:outlet
before attempting
to reverse rotation.
SPINDLE
USE OF CUTTER
SPACERS
1; The
spacers
can
be positioned
below
and
above
the
cutter,
Notice
when the spacer is positioned
below
the cutter
how the spacer
proVides
a bearing surface for the uncut
edge of the board,
in addition
to its use as a spacer
in
vertical
positioning
of the cutter.
__SPACER
/
SPINDLE
f
y
DIRECTION
KEYED
OF FEED
WASHER
"_CUTTER
k
TABLE INSERT
2;:This
same :cutter can be inverted
and mounted
to
produce a Shape with the board fed through in the
ooposite direction I F DIRECTION
OF- ROTATION
OF
THE SPINDLE
IS REVERSED,
Notice how the spacer again provides a bearing surface
for the uncut edge of the board.
3. Cut the workpiece to size, so the shaping cut will be as
light as possible to produce the desired pattern.
CAUTION:
Do not attempt to usethe Shaper for sizing
a workpiece (except when using the jointer cutter and
adjustable fence).
4.
Feed workpiece against rotation of cutter.
NOTE: It is a very good practice to make a trial cut on
a piece of scrap wood as a double check on the set-up
before usingthe actual workpiece.
CAUTION:
Serious injury may result if workpiece is
not always fed into the cutter against the direction of
rotation of the cutter, Use a smooth even pressure.
Experience will:soon
reveal the best rate of feed for
producing rite Smoothest cut,
5. If :the :Cut removes materia_ Over the entire ed
reducing the Width 0f_t!_e work
fence ir_ fron_
enough:to provid,
it passesthee:utter: This!
mg
to
support the workpiece.
/ SPACER
DIRECTION
/
OF FEED
DIRECTION
OF
ROTATI 0 N
NOTE:
TABLE INSERT
REMOVED
" :
:i •. • •
.
• :
•16
Advertisement
