Troubleshooting Table - Craftsman Weedwacker 358.799470 Operator's Manual

TROUBLESHOOTING TABLE
_JhWARNING: Always stop unit and disconnectfrom the power source before
performing all ofthe recommended remedies below except remedies that re-
quire unit to be operating.
TROUBLE CAUSE REMEDY
Semi-automatic 1, Crowling trimmer line 1, Allow tip of line to do the cutting.
head stops against meter;st being
under a load or cut.
does not turn 2, Electrical failure. 2, Contact your Sears Se_oe Center,
when switch is 3, Thrown circuit breaker, 3, Check Breaker Box,
_ressed, 4, Debris stopping heed. 4. Remove debris,
Line does not 1. Une improperly routed 1. Check Linerouting.
advance or in heed,
breaks while 2. Line improperly 2. Rewind line tighUy and evenly.
cutting, wound onto spool.
3. incorrect line size
3. Use only ,065 in. t.65mm) die. line.
4. Not enough line 4, Remove cover and pull 4 in,
outside of heed, (10 cm) of line out of heed.
5. Dirt buildup on unit, 5. Clean unit,
Line waids onto 1. Line size is inc_xreut. 1. Use only .065 in. (1.65mm) die` line,
spool, 2. Incorrect SPOOL 2. Replace with correct spool
3. Line is being crowded 3. Cut with tip of line fully extended,
against material being
cut.
Line releases 1. Line improperly 1. Check line routing.
continuous y. routed in heed, 2. Spool damaged, 2. Replace spool.
.ine usage is 1. Line impropl:dy routed 1. Check line routing.
_xcesaive, in head, _"
2, Line size is incorrect, 2. Replace SPOOL
3. CrowdingUne against 3. Cut with tip of line fully extended,
matedaibeing cut,
4. Spool worn or demaged, 4, Replane spool.
.ine pulls back 1. Too little line outside 1. Remove cover and pull 4 in.
nto head, of head, (10 cm) of line outside of head,
2, Line size Incorrect. 2. Use only .065 in, (1.65 mm) die. line.
10