I: I Assembly; I: I Iboiting Spindle Sander To Workbench; Maintenance - Craftsman 113.225705 Owner's Manual

CAUTION: To avoid injury from tool movement,
supporting surface where spindle sander is
mounted should be examined carefully after
mounting to insure no movement during use can
result_ If any tipping or walking is noticed, secure
to workbench or supporting surface before operat-
ing spindle sander.
Bolting Spindle Sander To.Workbench
If Spindle sander isto be used in a permanent location, it
should be fastened securely to a firm supporting surface
such as a workbench. If mounting to a workbench, holes
should be drilled through supporting surface of the work-
bench using dimensions as shown.
1. The unit should be bolted securely using 1/4" screws,
washers and hex nuts (not included). Screw length
should be 1-1/2" plus the thickness of thebench top.
Locate and mark the holes where sander is to be
mounted.
Drill (4) 3/8" diameter holes through workbench,
Place sander on workbench, aligning holes on base
with holes drilled in workbench.
Insert (4) 1/4" diameter screws and washers and
attach nuts securely.
1
,
3.
4.
5.
I CAUTION: To avoid injury from tool movement, use
lf4" diameter screws and nuts.
Rubber Feet
-IT fl
O •
11-t/2"
Front
1
1__
l! •
17-1t8"
8