Black & Decker Spacemaker CO100 Use And Care Book Manual page 4

GETTING ST RTED
• Remove all packing material, labels and any stickers.
• Remove and save literature.
• Unpack mounting parts and set them aside in a safe place where they will not
roll away or get lost.
Important: Do not attempt to operate appliance until it is properly installed.
CHOOSE LOC TION
When choosing your location, consider the following:
• DO make sure to mount within reach of an electrical outlet.
• DO consider your normal work patterns in the kitchen when choosing
location.
• DO NOT mount over any heating or cooking appliance such as your range or
oven.
• DO NOT mount over or near a sink.
• DO NOT mount under, in front of or behind any under-cabinet light fixtures.
Note: If mounting multiple †SpaceMaker™ appliances and you are installing your
appliance next to the SpaceMaker™ oven (Fig. .):
• llow at least 1" between the control panel side of the oven and the appliance.
• llow at least 4" between the side opposite the control panel of your oven and
adjacent wall or other appliance. You can mount the other appliances flush to
one another.
4"
4"
.
6
1"
1"
Note: If you are connecting this appliance to the receptacle of another
†SpaceMaker™ appliance such as the toaster oven or coffeemaker, make sure you
can easily unplug the appliance following use.
DETERMINE C BINET TYPE
Prior to installation, determine if your cabinet has a flat bottom (B) or an
overhang molding (C). If your cabinet is flat, follow ST ND RD INST LL TION;
if the cabinet has an overhang molding, refer to OVERH NG MOLDING
INST LL TION.
B
ST ND RD INST LL TION (FL T C BINET)
Important: lways wear protective glasses or goggles to prevent injury when
drilling.
1. Clear countertop under installation area to avoid getting dust or debris on other
appliances or items. Open cabinets and remove contents to make mounting
easier.
2. Clean both the underside and topside of the bottom panel of the cabinet.
3. With cabinet doors open, place mounting template flush against the surface of
the underside of your cabinet, making sure to align thick line on template with
bottom front edge of your cabinet (D).
D
Important: Do not align screw holes on template directly under the partition
between cabinets, as this will prevent you from installing the appliance properly.
Pay close attention to where the drill holes will be set so as not to damage your
cabinets during mounting. Drilling through your cabinet's partition may cause
damage to cabinets and prevent proper installation.
4. Fold the template along the edge of your cabinet so the thick line is straight
with bottom front edge; pull template tight and tape down to hold in place.
C
7