Download Print this page

Setting Up The Mini Timer; Setting The Clock; Controlling X10 Modules - X10 MT12A Owner's Manual

Mini timer
Hide thumbs

Advertisement

Table of Contents

Setting up the Mini Timer

Setting the clock

Plug the Mini Timer into any convenient AC outlet. Fit two AA alkaline batteries in the
battery compartment to protect the time and program for up to 48 hours in the event of a
power outage. If the battery is low, dead, or not installed, the low battery indicator will
show in the display.
When you first plug in the Mini Timer the display will flash. It will also flash if you have
had a power outage and have not installed two AA alkaline batteries or if the batteries
are dead.
1. Set the mode switch to "Clock Set."
2. Press the top of the "Time" rocker to advance to the correct time. A
quick press on the rocker will advance the time by 1 minute. If you
hold the rocker down the display will advance to the correct time
faster. If you overshoot, you can use the bottom rocker to go back.

Controlling X10 Modules

Follow the steps below to make sure you can control your Modules before you program
the Mini Timer.
1. Install and set up all of your X10 Modules referring to the instructions included with
them. Be sure to turn off the power at the main circuit breaker panel when
installing Wall Switch Modules.
2. Set all of your Modules to the same Housecode as the Mini Timer (default is A).
3. Set each Module to a Unit Code Between 1 and 8.
4. Set the Mode Switch on the Mini Timer to the "RUN" position.
5. To turn On a particular Module, set the selector switch to 1-4 or 5-8, then press the
ON button corresponding to the number you set on the Module you want to control.
6. To turn Off a particular Module, set the selector switch to 1-4 or 5-8, then press the
OFF button corresponding to the number you set on the Module you want to control.
The display shows On or Off next to the module number for the button you pressed.
To turn on ALL lights connected to Lamp Modules and Wall Switch Modules (with the
same Housecode as the Mini Timer), press the "All Lights On" button. This does not
affect appliances.
To turn off ALL lights AND appliances connected to any kind of X10 Module (with the
same Housecode as the Mini Timer), including Appliance Modules, press the "All Off"
button.
7

Advertisement

Table of Contents
loading

  Related Manuals for X10 MT12A