Download Print this page

Setting Up The Modules - X10 MT12A Owner's Manual

Mini timer
Hide thumbs

Advertisement

Table of Contents
Setting up the Lamp Module
Setting The Lamp Module's Code
(modules sold separately)
Using a small screwdriver, set the red House
Code dial to the same letter as your Mini
Timer. Set the Black Unit Code dial to any
unused number.
Ratings
The Lamp Module can be used to control an incandescent lamp rated up to 300W. It is
NOT suitable for other types of lamps such as fluorescent or energy saving lamps, low
voltage lamps, or lamps that include a dimmer control. Caution: Do not connect an
appliance such as a coffee pot or heater to a Lamp Module. It may damage the Module
and/or the appliance and could cause a fire hazard. Use an Appliance Module instead.
1.
Set the House
Code and Unit
Code.
Testing The Lamp Module
Make sure the lamp's switch is on. Plug the Module into the same wall outlet as your
Mini Timer, press the ON and OFF buttons on the Mini Timer that correspond to the
Unit Code setting on the Module. If the Module turns On and Off you can unplug the
Module or Mini Timer and move it to its permanent location. If you can't control the
module, contact www.x10.com/support for help.
2.
Plug a lamp into
the Module.
14
UNIT CODE
DIAL
HOUSE CODE
DIAL
3.
Plug the Module into
the same wall outlet
as your controller (see
testing below).

Advertisement

Table of Contents
loading

  Related Manuals for X10 MT12A