Connection Center On Back Of Tv; Input Sources For Your Tv; Stereo Audio Output - Zenith Sentry 2 Operating Manual & Warranty

CONNECTIONS FOR YOUR TV
CONNECTION CENTER ON BACK OF TV
The connection center on the rear of your TV allows you to
connect two viewing sources to your TV, and an external
stereo sound amplifier, if desired. You can choose from a
variety of audio/video components for your viewing
pleasure. The diagram below lists the use of each jack on
the connection center.
1. VHF-UHF/CABLE
Use this jack for 75-ohm, antenna-type signal con-
nection to your TV. Attach your antenna, cable-TV
line, or other video component to this jack. The
input cable may come from an outdoor or master
antenna, cable-TV line, cable-TV decoder box, or
the RF output from a VCR.
2. AUX (Auxiliary) INPUT VIDEO
Video (Base Band) input from VCR or other video
equipment (Disc Player). Gives improved picture
quality performance over that obtained through the
VHF-UHF/CABLE jack.
3. AUX (Auxiliary) INPUT AUDIO RIGHT and LEFT
Stereo audio input from VCR or other video equip-
ment (Disc Player).
4. SPEAKER EXT/INT Switch
EXT position: TV's speakers are off.
INT position: TV's speakers are on.
5. VARIABLE AUDIO OUTPUT RIGHT and LEFT
Stereo audio output for customer's audio amplifier.
This output is always present regardless of the posi-
tion of the SPEAKER switch.
RIGHT LEFT
O Q*
VARIABLE AUDIO
OUTPUT
E=
SPEAKER
VHF-UHF/CABLE AUX INPUT
VIDEO AUDIO
000
INPUT SOURCES FOR YOUR TV
Your TV has two input connection areas: one is marked
VHF-UHF/CABLE and the other AUX INPUT VIDEO -
AUX INPUT AUDIO RIGHT and LEFT. These two in-
puts allow you to connect two different "signal sources" to
your TV at the same time. The "Signal Source" refers to the
item supplying the picture and sound to your TV.
The most common "signal source" is your outdoor antenna
(or master antenna) or a cable-TV system. This type of sig-
nal is called a radio frequency (RF) source, and is con-
nected to the VHF-UHF/CABLE input connector.
Another common "signal source" is the audio and v_deo
(A/V) from a VCR or video disc player. This type of signal is
called base band (basic video and audio), and is connected to
the AUX INPUT VIDEO - AUX INPUT AUDIO RIGHT
and LEFT connectors. To use these VCR connections, you
must watch the AUX channel on the TV. To select the AUX
channel, press CHANNEL (CH) Up/Down until you select
the next channel after the highest/lowest channel, or enter the
number 999 from the remote control, or press SOURCE on
the remote control if available.
STEREO AUDIO OUTPUT
Your TV provides stereo audio output suitable for connec-
tion to your stereo sound system. Connect the VARIABLE
AUDIO OUTPUT RIGHT and LEFT jacks to an unused
input on your stereo amplifier. You may continue to listen
to the sound coming from the TV's speakers, or switch off
the TV's speakers as desired.
_sg-o 1 -- 1