Connecting To The Lan Line; Network Environment Settings - Sanyo WXU30 - PLC - LCD Projector Owner's Manual

Network set-up and operation
Hide thumbs Also See for WXU30 - PLC - LCD Projector:
Table of Contents

Advertisement

Chapter 4 Wired LAN configurations
Setting procedures and contents differ depending on the LAN installation location.
When installing, consult your system administrator to set up the LAN appropriately.

Connecting to the LAN line

Connect the LAN cable to the LAN connection terminal of the projector.

Network environment settings

Set the Wired LAN network through the projector menu.
Detailed network settings will be made with browser. Refer to "6. Basic setting and operation" (p43-62).
First, complete the settings described in this chapter before performing steps in "6. Basic setting and
operation. "
Setting Procedure
1. Turn on the projector and select "Wired" from the input menu of the projector.
The projector's LINK/ACT Lamp will be on or blink. If the "Wired setting" is "Off", it will not be on.
Follow step 2 and 3 to blink the lamp.
2. Select "Wired Setting" in the projector menu, and press SELECT button.
Select similar LAN environment among LAN1, 2 and 3 with the Point 7 8 buttons. (LAN1, 2, and 3
are the factory default setting environments. You can select three different environment among
setting LAN1–3. For each setting, refer to the chart on page 31.)
When selecting "Off" in the "Wired setting", the LAN connection will be cut off. Use the function
when disconnecting the projector from the network.
3. Press the Point 7 8 buttons then the "Please wait... " message will appear and switching operation
will start. Switching will take a while and after completing the operation, the "Ready for use" message
will appear. During the switching period, the projector cannot be operated.
26
LAN Connection
Terminal
LAN Cable
SD
* When the LAN setting is "Off", the two lamps
will not be on.
LINK/ACT Lamp (Orange)
Light or blink orange when
the projector is connected
to the network.
Speed Lamp (Green)
Light according to the
speed of the connected
network.
10 Base-T.........Off
100 Base-T ......On

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wxu30

Table of Contents