Chapter 6 Inidividual Command Specifications; Line Feed "Lf - Epson STYLUS 870 Programming Manual

CHAPTER 6 INIDIVIDUAL COMMAND SPECIFICATIONS

6.1

Line feed "LF"

Format:
ASCII
Hex
Decimal
Function:
1) Advances the printing position in the Y direction from the current one in the
positive Y direction by an amount equal to the current line separation amount. Sets the printing
position in the X direction to the starting point (the left margin position) on the X axis of the
position management coordinate system.
2) If this commands sets the Y direction printing position into the non-printable
region, then the page is ejected, the position management coordinate system is set to the next
page, and the printing position is set to the origin on this new position management coordinate
system.
Initial State: -
Related Commands:
Commands related in the direction of applying an effect (Setting)
None
Commands related in the direction of receiving an effect (Setting)
None
Commands related in the direction of applying an effect (Operation)
None
Commands related in the direction of receiving an effect (Operation)
The line advance amount is set by the ESC + commands.
The non-printable region is set by the ESC (c commands.
The line advance amount, the non-printable region, and the left margin position
are reset to their initial states by the ESC @ and ESC (G commands.
EPSON Imaging Technology Center
Revision: 1
LF
0A
10
Page: 21
10/6/00