Installing And Uninstalling For Unix Systems; Installing For Unix Systems; Cd Device File Names - HP StorageWorks P9000 User Manual

Installing and Uninstalling for UNIX Systems

This section discusses installing, uninstalling, upgrading, and downgrading of the Data Exchange
Code Converter program using UNIX systems.

Installing for UNIX Systems

1. Log in to the open systems server (UNIX server) as root.
2. To mount Code Converter, insert CD into the drive.
3. Go to the working directory of the installation server, and then use the following tar command
to copy all files in the installation media to the working directory. The Code Converter files listed
in Table 2
specifying the CD device file name as shown in the following table:
#tar xvf xxxxxx/libuoc.tar
Table 5 CD Device File Names
HP-UX 10.20 or later
Tru64 UNIX V5.1 or
later
AIX 4.3.3 or later
Solaris 2.6 or later
For further information regarding supported operating systems, contact your HP technical repres-
entative.
NOTE:
When you mount the CD, file names/directory names may not be displayed in all caps as shown
in Table
the file name. In these cases, you have to place single quotes around the file name. Check on
the file name using the "ls" command.
4. Remove the CD for Code Converter from the drive.
5. Save libuoc.* in /user/lib under another file name. Specify the file extension for your operating
system according to
6. Move the shared library to /usr/lib/: # mv -f libuoc.* /usr/lib. Specify the file extension
for your operating system according to
7. Move the version information file to /usr/lib/:
# mv -f libuoc.ver /usr/lib
IMPORTANT:
The FCU cannot operate unless this is done.
on page 30 will be stored in the working directory of open systems. Enter the following,
OS Installation
Media
CD
CD
CD
CD
5. You may also find a semicolon (;) plus one character, for example, ';l', at the end of
Table 3 on page 31.
Device File Name
(Mount point)/PROGRAM/CONVERT/MAIN/HP_UX/
(Mount point)/PROGRAM/CONVERT/MAIN/DIGITAL/
(Mount point)/PROGRAM/CONVERT/MAIN/AIX/
(Mount point)/PROGRAM/CONVERT/MAIN/SOLARIS/
Table 3 on page 31.
P9000 Data Exchange Code Converter User Guide 33