HP StorageWorks P9000 Manual page 31

Table 2 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKA0x) (continued)
Message ID Message Text
YKA002E TSO HANDLE() parameter
required for this operation
YKA003E TSO OP(OPEN|GET|CLOSE)
option required
YKA004E TSO Buffer full; messages
discarded
YKA006E TSO SYSTEM ERROR. error-type
YKA007E TSO TIMEOUT() value not valid
YKA008E TSO TIMEOUT() parameter
cannot be specified for this
operation
YKA009E TSO MSGID() value not valid
YKA010E TSO MSGID() parameter cannot
be specified for this
operation
YKA096I TSO No message found
YKA097I TSO message-text
YKA098I TSO HANDLE(x'handle')
YKA099I TSO Close operation complete
Explanation and Recommended Actions
The OP(GET) and OP(CLOSE) requests require the HANDLE
parameter to be specified.
Use the handle value returned by the OP(OPEN) request in the
YKA098I message.
The OP parameter is missing.
Specify the OP parameter.
An attempt to acquire the IEA494I console message, IOSHM0414I
console message, or the message specified in the MSGID parameter
of the YKCONMSG command failed. This problem might occur when
console message traffic is too high or when the YKCONMSG
command issuance interval is too long.
When you receive this message, issue the YKQUERY command to
check the copy pair status.
A system error was detected.
Contact technical support for assistance.
error-type
Type of system error
The value specified in the TIMEOUT parameter is invalid.
If GET or CLOSE is specified in the OP parameter, you cannot
specify the TIMEOUT parameter.
Specify OPEN in the OP parameter, and then specify the TIMEOUT
parameter.
The value specified in the MSGID parameter is invalid.
If GET or CLOSE is specified in the OP parameter, you cannot
specify the MSGID parameter.
Specify OPEN in the OP parameter, and then specify the MSGID
parameter.
Processing of the YKCONMSG command with OP(GET) specified
exceeded the time specified in the TIMEOUT parameter, but the
IEA494I console message, IOSHM0414I console message, or
the message specified in the MSGID parameter of the YKCONMSG
command has not yet arrived.
Re-execute the YKCONMSG command with OP(GET) specified after
the system becomes ready to receive messages.
The YKCONMSG command with OP(GET) specified returned the
IEA494I console message, IOSHM0414I console message, or
the message message-text specified in the MSGID parameter of the
YKCONMSG command in the order in which the messages arrived.
The YKCONMSG command with the OP(OPEN) parameter specified
was executed successfully.
From now on, if you execute the YKCONMSG command with the
OP(GET) or OP(CLOSE) parameter specified, use the returned
handle value in handle.
The YKCONMSG command with the OP(OPEN) parameter specified
terminated normally.
List of Messages 31