HP StorageWorks P9000 Reference Manual page 367

Monitors the copy group.
If you specify ACTIVE for more than one copy group, the first copy group that is specified will be
monitored. When the status of this copy group changes to INACTIVE while BCM Monitor is
running, the next copy group for which ACTIVE is specified is placed in the monitoring status.
INACTIVE
Does not montior the copy group.
CGSTARTUPSTATUS=startup-status,startup-action[,NOCANCEL]
If this parameter is specified and the copy group status is not the specified startup status when
BCM Monitor starts, the specified startup action is executed.
The processing of this parameter is also for copy groups that has ACTIVE or INACTIVE specified
for the CGMONSTAT parameter.
The YKSUSPND command with the CANCEL parameter specified is executed if all of the following
conditions are satisfied:
The copy group is a BC or TCA consistency group.
DUPLEX is specified as the startup status.
The status of the copy group is DUPLEX, or ADJUST is specified as the startup action.
NOCANCEL is not specified.
If you do not want to execute the YKSUSPND command with the CANCEL parameter specified,
specify NOCANCEL.
If the copy group contains a copy pair in the TRANS or HOLDTRNS status, CGSTARTUPSTATUS
parameter processing is executed after the following processing is performed:
When there is a copy pair in the TRANS status:
The YKEWAIT GOTO(SUSPEND) TIMEOUT(WAITTIMEOUT) command is executed.
When there is a copy pair in the HOLDTRNS status:
The YKEWAIT GOTO(HOLD) TIMEOUT(WAITTIMEOUT) command is executed.
The value for WAITTIMEOUT is the value specified for the WAITTIMEOUT parameter in the
YKMONOPT file.
startup-status
Checks whether all the copy pair statuses in the copy group are the specified startup status. The
permitted values are SIMPLEX, DUPLEX, SUSPOP, or HOLD.
startup-action
Specifies the action to be executed if the copy group contains a copy pair that is not in the specified
startup status. The permitted values are as follows:
EXIT(return-code) ~ <numeric characters> ((0 to 4095))
Stops BCM Monitor with the specified return code. HP recommends that you specify a value other
than 0, 4, 8, or 12 because these numbers are already used as BCM Monitor return codes.
STOP
Changes the monitoring status of all the copy groups specified in the CGID parameter to INACTIVE.
ADJUST
Changes the copy pair status to the specified startup status.
YKMONCG File 367