HP StorageWorks P9000 Reference Manual page 36

Figure 22 CU Selection List for Remote Storage System Panel
Table 16 (page 36)
Table 16 Contents of the CU Selection List for Remote Storage System Panel
Item
Device Address Domain
Description
Storage System S/N
Model
uCode
IFType
Software Keys
AC
CU
SSID
Dummy Devn
Information
If any of the volumes detected in a remote scan or NG scan has not been assigned a dummy
device number (that is, if NOTSET is displayed under Information for any volume), the CU Selection
List for Remote Storage Array panel cannot be closed. In such cases, pressing F3=Exit generates
an error message.
If a command device is not contained within the scanned range specified in the Scan Remote
Device Address Extent panel, the dummy device numbers are not assigned to the command devices.
For example, the CU Selection List for the Remote Storage System panel that is displayed after the
36 ISPF Panels
describes the items in the CU Selection List for Remote Storage System panel.
Description
DAD ID to which the CU belongs
Description of the storage system to which the CU belongs
Serial number of the storage system to which the CU belongs
Model of the storage system to which the CU belongs
Microcode information for the storage system to which the CU belongs
Interface version of the storage system to which the CU belongs
CA Setting for use of the copy type by the storage system:
Y— Copy type can be used.
CAA
N— Copy type cannot be used.
BC
CAJ
Specify an action:
s— Displays the CCA Selection List for Remote Storage Array panel which
identifies detailed information about the CU.
e— Displays the Edit Device Number for CU panel used to assign a dummy
device number to the CU.
Control unit number
SSID of the CU
Dummy device number assigned to the start device (the device with the lowest
CCA) in the CU
Display when dummy device number not assigned to CU-NOTSET