Cu Selection List For Remote Storage Array Panel - HP StorageWorks P9000 Reference Manual

Table 14 Contents of the Scan Device Address Extent Panel (continued)
Item
Storage System
S/N
Device Address
When the F6=Scan key is pressed after the items in
are scanned within the specified range. If an invalid character is specified, or if the value specified
for Start is greater than the value specified for End, an error message prompts you to re-enter the
values.
After the local scanning operation, the number of detected volumes is displayed. The new information
is displayed in the Discover HP Storage System panel. After the NG scan is completed, the panel
transitions to the CU Selection List for Remote Storage System panel. The information on the scanned
volume configuration is saved in the disk configuration definition file. A name that conforms to the
value of Configuration File Prefix and Local Device Address Domain ID in the Set Defaults panel or
Non Gen'ed Device Address Domain is assigned to the file using the following format:
prefix.DSK.SNnnnnn.dad-id
When entering prefix and dad-id information, the names must be specified using no more than
44 characters.
NOTE: describes the command devices used when an NG scan is performed. If you want to
change the command device to be used, modify the environment according to information in
Table 15 (page
Table 15 Command Devices Used when NG Scan is Performed
Value specified for Remote DKC
Function in the Set Defaults panel
N
Y

CU Selection List for Remote Storage Array Panel

If any of the following operations are executed, the CU Selection List for Remote Storage Array
panel with a list of CUs detected by the remote scan or NG scan is displayed.
The F6=Scan key is pressed in the Scan Remote Device Address Extent panel.
Non Gen'ed is selected and the F6=Scan key is pressed in the Scan Device Address Extent
panel.
e is specified in the AC column in the Discover HP Storage System panel.
Figure 22 (page 36)
Description
Serial number of the storage system to be scanned.
Specify the Start and End of the device address (CU and CCA) range to be scanned.
Specify the hexadecimal number in ascending order. If the CCA is omitted, the Start and End will
be set to 00 and FF respectively.
35).
First entry of the route list specified for
Preset RouteListID in the Set Defaults
Not applicable
If the storage system is not a target for
the NG scan
If the storage system is not a target for
the NG scan
shows the CU Selection List for Remote Storage Array panel.
Discover/Define Configuration Panel (Configuration File Definition)
Table 14 (page 34)
Command device used when an NG
panel
The first command device of the list that
was sorted in ascending order by CU
and CCA. The list includes the
command devices that have been
detected by the local scan.
The first entry (command device) of the
route list that has been specified for
Preset RouteListID.
are specified, volumes
scan is performed
35