Logical Path Status Of Copy Group Pair Panel - HP StorageWorks P9000 Reference Manual

The path information displayed in the Path Set Status of Copy Group Pair panel differs depending
on the copy type:
When the copy type is CA/CAA, path information for the inter-control unit logical path in the
copy direction is displayed
When the copy type is CAJ, path information for the bidirectional inter-disk controller logical
path is displayed.
When the copy type is BC, no path information is displayed.
The execution result of the YKQRYDEV command with the PATH parameter specified is displayed
in the RC column in the Copy Group Pair Status panel.
Pair Status panel" (page 173)
panel.
Table 90 Return codes displayed in the Copy Group Pair Status panel
Return Code
00
04
Other than the above
In the Path Set Status of Copy Group Pair panel, you can use the SORT command. For details
about how to use the SORT command, see
Pressing the F6=Sort key in the Path Set Status of Copy Group Pair panel displays the Sort Logical
Paths in the Path Set panel that sorts the logical paths in the path set. For details about the Sort
Logical Paths in the Path Set panel, see

Logical Path Status of Copy Group Pair Panel

When s is specified for the AC column in the Path Set Status of Copy Group Pair panel, the physical
paths within the logical paths used by the copy pair are displayed in the Logical Path Status of
Copy Group Pair panel.
Figure 133 (page 174)
describes the return codes displayed in the Copy Group Pair Status
Meaning
Successful completion.
If no path information is displayed, then there is no path used by the copy pair
selected in the Copy Group Pair Status panel.
Path information cannot be displayed for one of the following reasons:
The device information during definition, as indicated by Primary
Volume/Secondary Volume in the Copy Group Pair Status panel, differs
from the device information reported by the storage system. View the Volume
Query Information panel for the relevant copy pair to check the configuration
file in use, as well as the actual storage system configuration information
and settings.
If the device indicated by Primary Volume/Secondary Volume in the Copy
Group Pair Status panel is a remote site, then either the route list is not
specified, or the serial number of the storage system to which the device
belongs is not registered in the route list specified for the YKLOAD command.
Return code of the YKQRYDEV command.
"Command Line Commands" (page
"Sort Logical Paths in Path Set Panel" (page
shows the Logical Path Status of Copy Group Pair panel.
" Return codes displayed in the Copy Group
Manage Copy Groups Panel (Copy Group Operation) 173
11).
68).