Setting Up For Fcoe Connectivity; Fcoe End-To-End Fabric-Connect Eva Storage Configuration - HP StorageWorks MPX200 User Manual

Hp storageworks mpx200 multifunction router user guide (5697-0568, august 2010)
Hide thumbs Also See for StorageWorks MPX200:
Table of Contents

Advertisement

Servers with CNAs
Converged
network
FCoE/iSCSI
MPX200
FCoE/iSCSI
target
Fabric A
Figure 99 FCoE end-to-end fabric-connect EVA storage configuration
.

Setting up for FCoE connectivity

Before executing the following procedure, ensure that MPX200 discovery has been completed as
described in
Chapter 3
To set up for FCoE:
1.
Configure the FCoE enabled converged network switch. Depending on the switch vendor, configure
the ports for FCoE use.
For information regarding switch setup, see the Fibre Channel Over Ethernt Application Note at
the website:
c01764474.pdf.
The MPX200 10-GbE ports must be connected to the FCoE switch, as described in the section
"FCoE
configurations" on page 145.
2.
Set up the Converged Network Adapter (CNA). For more information regarding CNA
configuration, see the Converged Network Adapter Installation Guide at:
http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c02018539/
c02018539.pdf
a.
Install the driver for the CNA.
b.
Depending on the CNA vendor, use the management tool to determine the WWNN/WWPN
for each port on the CNA.
146
MPX200 FCoE feature description
Servers with NICs
FCoE/IP
/iSCSI
iSCSI/IP
FCoE switches
HP StorageWorks
HP StorageWorks
10GbE4
10GbE3
10GbE4
10GbE3
MPX200
10 - 1 GbE Blade
MPX200
10 - 1 GbE Blade
MPX200 Multifunction Router
MPX200 Multifunction Router
MGMT
IOIOI
FC1
FC2
GE1
GE2
MGMT
IOIOI
FC1
FC2
GE1
GE2
Fibre
Channel
EVA Storage Systems
on page 35.
http://bizsupport2.austin.hp.com/bc/docs/support/SupportManual/c01764474/
IP
Ethernet
Network
Fabric B
26653a

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xp20000/xp24000

Table of Contents