Connecting The Supplied Power Cable - NEC NP1150 - XGA LCD Projector User Manual

Np1150/2150/3150/3151w user's manual
Hide thumbs Also See for NP1150 - XGA LCD Projector:
Table of Contents

Advertisement

Connecting the Supplied Power Cable

Connect the supplied power cable to the projector.
First connect the supplied power cable's three-pin plug to the AC IN of the projector, and then connect the other
plug of the supplied power cable in the wall outlet.
to wall outlet
Make sure that the prongs are fully
inserted into both the aC in and the
wall outlet.
About Direct power Off
The projector has a feature called "Direct Power Off". This feature allows the projector to be turned off (even when
projecting an image) using a power strip equipped with a switch and a breaker.
NOTE: Before using Direct Power Off, be sure to allow at least 20 minutes immediately after turning on the projector and starting
to display an image.
CAUTION:
Do not try to touch the ventilation outlet on the left front (when seen from the front) as it can become heated
while the projector is turned on and immediately after the projector is turned off.
CAUTION:
Do not unplug the power cable from the wall outlet or projector when the projector is powered on. Doing so can
cause damage to the AC IN connector of the projector and (or) the prong plug of the power cable.
TIP: To turn off the AC power supply when the projector is powered on, use a power strip equipped with a switch and a breaker.
2. Installation and Connections


Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents