Setup
Flushing the gun
Flush the spray gun before putting any paint
through the gun.
WARNING
Read warnings, page 3. Follow Top and bottom feed
guns installation, page 8.
1. To flush the gun, use a solvent that is compatible
with paint to be sprayed. Hold a metal part of the
gun firmly to a grounded metal pail. Trigger the gun
to flush solvent through gun.
F
. 2
IG
Connecting the air line
2. Install an air pressure regulator (F). See F
310692D
3. Install an air filter (G). See F
4. Use a 5/16 inch (7.9 mm) I.D. air hose to minimize
5. Connect the air hose (D) to the 1/4 npsm gun air
F
IG
6. Connect the other end of the air hose (D) to a regu-
ti4836a
F
IG
. 1.
IG
excessive pressure drop in the hose.
inlet (C).
. 3
lated air supply line.
ti4838a
. 4
Setup
. 1.
IG
C
D
ti4837a
D
9