Table of Contents
Advertisement
Boot Booster
The Boot Booster item in BIOS setup helps shorten your Disney Netpal
bootup time. However, you MUST disable this BIOS item before you
change any Disney Netpal components or perform system recovery
(from USB flash disk, external optical drive or hidden partition). Follow the
instructions below to disable Boot Booster:
1.
Start the system and press <F2> on bootup to show the POST
screen. Press <F2> again to enter the BIOS setup.
2.
Set Boot Booster to [Disabled]
If you fail to see the POST screen or enter the BIOS setup by doing
the instruction above, restart the system and try pressing <F2>
repeatedly on bootup.
Main
Boot Device Priority
Boot Settings Configuration
OnBoard LAN Boot ROM
Boot Booster
Press <F10> to save the configuration and restart Disney Netpal.
3.
Remember to enable Boot Booster after you complete hardware
change or system recovery.
4-6
BIOS SETUP UTILITY
Advanced
Security
v02.58 (C)Copyright 1985-2005, American Megatrends, Inc.
Chapter 4: Support DVD & System Recovery
Boot
Exit
[Enabled]
[Disabled]
Specifies the Boot
Device Priority
sequence.
A virtual floppy disk
drive (Floppy Drive B:
) may appear when you
set the CD-ROM drive
as the first boot
device.
Select Screen
←→
Select Item
↑↓
Enter Go to Sub Screen
F1
General Help
F10
Save and Exit
ESC
Exit
Advertisement
Table of Contents
