Table of Contents
Advertisement
UTILITY STITCHES ——————————————————————————————————————————————————
Attach buttonhole foot "A".
2
• For details, refer to "Replacing the presser
foot" (page 37).
46
Select stitch
3
Adjust the stitch width to the thickness of the
4
gimp thread.
5
Lower the presser foot lever and the
buttonhole lever, and then start sewing.
When sewing is finished, gently pull the gimp
6
thread to remove any slack.
7
Use a handsewing needle to pull the gimp
thread to the wrong side of the fabric, and
then tie it.
8
With a seam ripper, cut the middle part of the
gimp thread remaining at the top end of the
buttonhole.
Trim off any excess of the gimp thread.
82
47
or
.
Button sewing
Buttons can be sewn on with the sewing machine.
Buttons with 2 or with 4 holes can be attached.
1
Raise the presser foot lever, and then slide the
drop feed lever, located at the rear of the
machine on the base, to
seen from the front of the machine).
1
2
1 Drop feed lever
(as seen from the rear of the machine)
2 Back side
The feed dogs are lowered.
2
Attach button-sewing foot "M".
• For details, refer to "Replacing the presser
foot" (page 37).
(to the right as
Advertisement
Table of Contents
