Sony BRAVIA KDL-40Z4100 Operating Instructions Manual page 56

No color/Dark picture/Color • Press PICTURE to select the desired Picture Mode (see page 23).
is not correct / The picture is • Adjust the Picture Mode options in the Picture settings (see page 42).
too bright • If you set the Power Saving mode to Low or High, it will enhance the black
level (see page 53).
Noisy picture • Make sure that the antenna is connected using a 75-ohm coaxial cable.
• Keep the antenna cable away from other connecting cords.
• To avoid TV interference, make sure to use an undamaged antenna cable.
Blurry picture / Poor color • Transporting the TV from a cokt to a warm location or a sudden change in room
temperature may cause moisture condensation, resulting in a blurry picture or
poor color. Turn off your TV and wait a few hours before powering on again.
No Sound/Noisy sound
No sound / Good picture • Check the volume control.
• Press MUTING or VOL + so that "Mnting" disappears from the screen (page 21 ).
• Set Speakers to TV Speakers in the Sound settings (see page 45). If it is
set to Audio System, sound is not output from the TV's speakers regardless of
the TV's volume control.
• When using HDMI input with Super Audio CD or DVD-Audio, DIGITAL
AUDIO OUT (Optical) may not provide an audio signal.
• When tuned to a digital channel with Alternate
Audio,
the broadcaster may
not be broadcasting your preferred Alternate Audio language. Press
OPTIONS, highlight and select Alternate
Audio,
and change the Alternate
Audio language (see page 45).
Audio noise • Make sure that the antenna is connected using a 75-ohm coaxial cable.
• Keep the antenna cable away from other connecting cords.
• To avoid TV interference, make sure to use an undamaged antenna cable.
No Audio or Low Audio with • Press THEATER for BRAVIA Sync activated Theater System (see page 20).
Home Theater System • Set Speakers to Audio
System
in the Sound settings (see page 45).
• Set Audio Out to Fixed in the Sound settings (see page 45).
BRAVIA Sync
Cannot find connected • Make sure that the Control for HDMI is set up on both the TV and the optional
BRAVIA Sync HDMI device device compatible with BRAVIA Sync (see page 37).
Cannot control second AV • Only one A/V receiver may be used with the BRAVIA Sync and Control for
receiver HDMI fimctions at one time (see page 51).
PC |nput
No picture / No signal • Confirm the PC is correctly connected to the TV with either the PC IN (with an
HDI5 cable) or with the HDMI IN.
• Ensure the output signal from the PC is one of the formats listed on page 14.
• Turn the PC oft'. Confirm the PC connection and restart the PC. Plug-and-play
will auto-detect the TV and correctly set up PC tinting.
• Verity PC Power
Management
is activated (see page 53).
• Verify the PC is not in standby or hibernation mode.
Poor Picture • Adjust the resolution (see page 14).
• Adjust Pitch and Phase.
General
Wide Mode changes
automatically
• The current Wide Mode setting is automatically replaced with the 4:3
Default setting when you change the channel or video input, if 4:3 Default in
the Screen settings is set to other than Off. If you want to lock in Wide Mode
selected with WIDE on the remote control, set 4:3 Default to Off in the
Screen settings (see page 45).
• Check the Auto Wide option in the
Screen
settings (see page 45).
56