Brother Entrepreneur PR650e Operation Manual page 264

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Sewing cannot begin from the
specified starting position.
Change the starting position or
rehoop the fabric and change the
embroidering position. (Refer to
page 123, 124.)
The needle bar case has stopped at
an incorrect position.
Touch to automatically
reset the needle bar case.
Another operation was performed
while the automatic needle-
threading mechanism was
threading the needle.
Press the automatic needle
threading button, and then perform
the other operation after the needle
is threaded. (Refer to page 59.)
262
The needle has stopped at an
incorrect position.
Turn the handwheel so that the
mark on the handwheel is at the
top.
The needle bar case motor has
locked up.
Touch to automatically
reset the needle bar case.
Too many patterns are being
combined for the amount of
memory available.
Delete some patterns from the
combined pattern.
The needle bar case could not be
moved to its initial position.
Touch to automatically
reset the needle bar case.
The automatic needle-threading
mechanism did not operate
correctly.
Remove the thread entangled in the
automatic needle-threading
mechanism, and then touch
.
The pattern could not be saved
because the memory is full.
Delete some patterns.