Trimming The Threads Between Characters - Brother Entrepreneur PR650e Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
3 Use
is to be separated, and then touch
separate it. For this example, the pattern will
be separated between "T" and "a".
● A separated character pattern cannot be
combined again.
4 Use
then use
spacing.
to select where the pattern
Note
and to select a pattern, and
to adjust the character
5 Touch
to
Trimming the threads
between characters
If the machine is set to trim the threads between the
characters, the jumpstitches between the characters
are reduced and any other necessary procedures
after embroidering are reduced. However, the
embroidering time will increase if the threads are
trimmed between each of the characters.
1
Touch
• Each touch of the key turns the setting
either on or off.
Threads are not
trimmed.
Editing the Embroidery Pattern (Pattern Editing Screen) 169
.
so that it changes to
Threads are
trimmed.
.
5