Uninterrupted Embroidering (Using A Single Color) - Brother Entrepreneur PR650e Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
● Temporary needle bar setting only applies
until the next color change. If the pattern
contains another area with the same color
or when the same pattern is sewn the next
time, the area is sewn with the original
color.
● The thread color (needle bar) can be
changed with this procedure even when
the machine has been stopped with a
specified pause or at the time of spool
change.
● If the start/stop button was pressed to stop
the machine while an area was being
sewn, a temporary needle bar setting
cannot be applied. The thread color
(needle bar) cannot be changed in the
middle of an area that is being sewn.
Uninterrupted embroidering
(using a single color)
A selected pattern can be stitched out in one color
instead of multicolor. The machine will hesitate but
not stop between color steps, and then continue till
the pattern is completed.
1 Touch the key for the needle bar threaded
with the thread you wish to embroider
uninterruptedly.
2 Touch
The temporary needle bar setting screen
appears.
Memo
.
3 Touch for the multicolor steps to
become shaded and the selected pattern will
embroider in a single color, instead of
changing the thread while embroidering.
The thread color displayed on the screen
will be grayed out.
Memo
● If you touch any key of the needle bar
number above, the temporary needle bar
setting will be activated. (Refer to
page 130.)
• Touch again to return to the
pattern's original settings.
4 Touch .
Memo
● Even if uninterrupted embroidering has
been set, the DST thread trimming
function can be used (refer to page 199).
● You can select the needle bar on the
embroidering screen, even after touching
4
in step
● After finishing the embroidery,
uninterrupted embroidery will be
canceled.
Temporary Needle Bar Setting 131
.
4