Replacing The Heat Sink And Fan Assembly - Lenovo ThinkServer TS130 User Manual

(english) user guide
Hide thumbs Also See for ThinkServer TS130:
Table of Contents

Advertisement

What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to "Completing the parts replacement" on page 48.

Replacing the heat sink and fan assembly

Attention:
Do not open your server or attempt any repair before reading and understanding the Safety Information and the
Warranty and Support Information on the ThinkServer Documentation DVD that came with your product, and
"Guidelines" on page 15. To obtain a copy of the publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the heat sink and fan assembly.
CAUTION:
Turn off the server and wait three to five minutes to let the server cool before removing the server
cover.
To replace the heat sink and fan assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See "Removing the server cover" on page 17.
3. Lay the server on its side for easier access to the system board.
4. Locate the heat sink and fan assembly. See "Locating parts on the system board" on page 11.
5. Disconnect the heat sink and fan assembly cable from the microprocessor fan connector on the system
board. See "Locating parts on the system board" on page 11.
.
Chapter 5
Installing, removing, or replacing hardware
37

Advertisement

Table of Contents
loading

This manual is also suitable for:

1098110011051106

Table of Contents