Installing A Tape Drive - Lenovo ThinkServer TS100 Installation Manual

10. Connect one end of the applicable signal cable into the rear of the drive and
11. Route the signal cable so that it does not block the airflow to the rear of the
12. If you have another drive to install or remove, do so now.
13. Connect the power cable to the rear of the drive. The connectors are keyed
If you have other devices to install or remove, do so now; otherwise, go to
"Completing the installation" on page 30.

Installing a tape drive

To install a tape drive 3 , complete the following steps:
20
ThinkServer TS100 Types 6431, 6432, 6433, 6434: Installation Guide
1 Release buttons
2 Drive retainer clip
9. If you are installing a 5.25-inch drive in bay 2, slide the drive into the bay. If
you are installing a 3.5-inch drive in bay 2, you must attach the 5.25-inch
conversion kit to the 3.5-inch drive.
Note: An optional external diskette drive can only be installed in bay 3.
make sure that the other end of this cable is connected into the applicable
SATA connector on the system board.
drives or over the microprocessor and dual inline memory modules (DIMMs).
and can be inserted only one way.
1. Read the safety information that begins on page v and "Installation
guidelines" on page 7.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
3. Remove the side cover (see "Removing the side cover" on page 10).
4. Remove the two-piece bezel (see "Removing the two-piece bezel" on page 11).
5. Use a screwdriver to pry the filler panel 2 and EMC shield 1 away from
the server.
6. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and
place it on a static-protective surface.
7. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
8. Remove the drive retainer clip 4 from the side of the drive cage of bays one
or two. Slide the drive retainer clip to the right to remove it from the drive
cage; then, snap the drive retainer clip into the screw holes on the side of the
drive.