Initializing The Ethernet Card; Configuring For Dlc On Windows Nt - Epson Stylus Color 850N User Manual

Caution:
Don't use an outlet
controlled by a wall switch
or timer, or one that uses
the same circuit as a large
appliance. This may
disrupt the power, which
can erase memory or
even damage the power
supply.

Initializing the Ethernet Card

You only need to initialize the card under the following
conditions:
The first time you connect the printer to a network.
EPSON Net! cannot recognize the card because its settings
are incorrect.
You reinstall the card in a different printer.
To initialize the card, make sure the printer is turned off (the
power button should be up) and plug the printer into a properly
grounded outlet while pressing down the status sheet button for
at least three seconds.
status sheet button
To reset all card configuration settings to their factory defaults,
turn the printer on while pressing the status sheet button on the
card plate.
Configuring for DLC on
Windows NT 4.0
If you use Windows NT 4.0, the Ethernet card works with the
DLC (Data Link Control) protocol provided in your operating
system. Follow the instructions below to install DLC protocol
and configure the Ethernet card to use it.
6-5
Using the Ethernet Card