Setting Up The Epson Stylus Rip Server - Epson 7500 User Manual

Printing with EPSON Stylus RIP for Macintosh
Setting Up the EPSON Stylus RIP
Server
Follow the steps below to set up the EPSON Stylus RIP Server
software the first time you use it—you'll need to do this for
both standalone and network configurations.
1. Make sure the Stylus RIP Server application has at least
20MB of RAM available. Open the
your hard disk and highlight the
Choose
following Memory Requirements:
Note:
If you are not running your Macintosh with virtual memory
turned on, increase each of the Memory Requirements by
4000K.
2. Disable all desktop printing extensions.
3. Turn on the printer and wait to make sure its power light
comes on and the light is not flashing. Make sure the
printer is properly connected to your Macintosh or
network.
4. Start the Stylus RIP Server application by
double-clicking the
5. The first time you run the server software, a dialog box asks
you to select your port or your printer name. Select the
appropriate modem, printer, or USB port if you are
connected to the printer via a serial, USB, or EPSON USB
Adapter cable.
from the File menu, then set the
Get Info
Preferred Size 20000K
Minimum Size 16000K
StylusRIP Server
Stylus RIP
StylusRIP Server
2-2
folder on
icon.
icon.