Asf Disassembly - Epson 440 Service Manual

EPSON Stylus Color 600 Service Manual

3.2.5.5.1 ASF Disassembly

1. Removing the ASF. (Refer to section 3.2.5.5)
2. Remove "TWIST SPRING, 41.2" by unhooking one end from the ASF frame and remove "LEVER,
BRAKE".
3. Remove "BUSH, FIXING, SHAFT" from the right end of "SHAFT, ROLLER, LD" and remove
"LEVER, HOPPER, RELEASE".
4. Move the left paper pack-up assembly to the middle of the ASF and remove "BUSH" from the
shaft.
5. Push out "SHAFT, ROLLER, LD" to the left and remove "BUSH, FIXING, SHAFT, LEFT" from the
left-end of the shaft by unhook it.
6. Unhook the top of "HOPPER, ASSEMBLY" from the both sides of "FRAME, ASF".
7. Push out "SHAFT, ROLLER, LD" to the right while pulling up "PICKUP, ROLLER ASSEMBLY,
RIGHT" slightly. Then, detach the left end of "SHAFT, ROLLER, LD" from "FRAME, ASF".
8. Holds "HOPPER, ASSEMBLY" and remove the right cam part of "HOPPER, ASSEMBLY" through
the hole at the right side of "FRAME, ASF".
To this point, the ASF assembly is disassembled and both left and right "PICKUP, ROLLER ASSEMBLY"
and "HOPPER, ASSEMBLY" are separated.


When removing "HOPPER, ASSEMBLY", be careful that the grease that applied to the cam part
of it, is not attaching to other part of the ASF. If so, wipe it off completely.


Make sure that bushes at the both ends of the shaft are firmly attached.
3-20
WORK POINT
Figure 3-17. ASF Disassembly
Rev. A