Asf Assembly Removal - Epson 440 Service Manual

EPSON Stylus Color 600 Service Manual
3.2.5.5

ASF Assembly Removal

1. Removing the upper housing. (Refer to section 3.2.1)
2. Remove the locking pin from center of "GEAR, 34" and remove "GEAR, 34" from the shaft.
3. Unhook the cables from the cable hook of the ASF and the printer mechanism.
4. Remove 2 screws (Refer to the figures) fixing the ASF and remove the ASF from the mechanism
by detaching the projection of ASF (at left) from the hole of the mechanism.


Make sure that the ASF is firmly attached to the mechanism.


Use proper type of screw at specified position (viewed from the back of the mechanism):
Right: "SHAFT, FIXING, CR"
Left: Screw - No.7 (CBS with washer)
When re-installing the ASF, be sure that no cables (except the flat cable to the printhead) are pinched
between the ASF and the frame.
Especially, if the cables from CR/PF Motor is pinched, there is a danger of short-circuit with the frame
and possibly causes hazardous problem like over-heating, burning of components.
3-18
WORK POINT
CAUTION
Rev. A