No Ink-Cartridge Error; Maintenance Request; Fatal Errors - Epson 440 Service Manual

Color ink-jet printer
Hide thumbs Also See for 440:
Table of Contents

Advertisement

1.5.4

No Ink-Cartridge Error

Following reasons can be the causes when printer goes this error mode.

When the printer is turned on for the first time.
(This is a normal error state and it returns to the normal state after installing an ink cartridge
according to the ink cartridge exchange operation.)

Ink cartridge exchange operation is done correctly. After the position of carriage is moved by
exchange operation, if the cleaning switch is pushed without installing ink cartridge or if the
carriage returns to the home-position automatically without doing any operation, it is considered
as
handling mistake. However, it returns to normal state by performing ink exchange operation again
and installing cartridge correctly.

If "No ink-cartridge error" appears even after the ink cartridge is installed, the printer must be
something wrong and around the sensor area in the carriage need to be repaired.

If sometimes printer can print normally but also sometimes "No ink-cartridge error" appears, the
printer must be something wrong. (Same reason as above)
1.5.5

Maintenance Request

When the total quantity of ink wasted through the cleanings and flushing reaches to the limit, printer
indicates this error and stops. The absorber in the printer enclosure is needed to be replaced with new
one by a service person. The ink quantity that is absorbed by the absorber (waste ink pad) is monitored
by the software counter as "total ink counter". This counter is added by point system and absorber's
maximum ability is set at the following reference value.

1-point = 0.0102 ml (the value which is multiplied evaporating rate and 1-dot ink weight 0.02
ml)

29500 = Maximum point number (Maintenance error threshold)
However, considering dispersion of ink absorbing quantity and the number of using nozzles, ink total
value is calculated by the following formula.
When you perform self- test after completing repairs, it is possible to check the present value of total
ink counter and ink discharge conditions from all nozzles by performing status printing in the built-in
function. Therefore, make sure that the printer has enough value of total ink counter (if the number is
close to 29500 or not). If there is not enough value, the service man is required to judge if it is
necessary to clear EEPROM after replacing the absorber (waste ink pad) or not. Refer to section
1.3.1 if you need to perform EEPROM Clear.
1.5.6

Fatal Errors

When printer detects fatal errors such as carriage control error or CG access error, it goes to this error
mode. Refer to followings for each error.

Carriage control Error: Parallel adjustment malfunction, Home-position malfunction, Timing belt

CG Access Error:
Rev. A
29500 X 0.012 ml = Approximately 301ml
301 X 1.1/63% = 526ml (but up to 532ml can be retained)
tension malfunction, shortage of lubricant on the carriage guide shaft, etc.
Short circuit, etc.
WARNING
Chapter 1 Product Description
1-25

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Stylus color 600

Table of Contents