Condition For Programming Operations - TEC MA-1350-1 SERIES Owner's Manual

Condition for Programming Operations:

At the top of each programming operation sequence in this chapter, "Condition" is attached. Unless the
register satisfies this condition, the programming operations will not be allowed.
When Condition "After ... Reset" is attached:
"After ... Reset" means that the designated reset report must be taken before entering the programming
(setting) operation. An error will result if the operation is attempted without taking the report.
However, it does not necessarily mean "immediately after ..." When the designated reset report has al-
ready been taken and then some operations are performed in the "X", "Z", or "SET" mode, the condition
"After ... Reset" is still satisfied and the programming operation is stilled allowed.
On the contrary, when the designated reset report has been taken but then some sales data relating to
that report's output data are entered in the "REG", "MGR" or " - " mode, the programming operation
will no longer be allowed and the same reset report must be taken again.
Thus, the condition "After ... Reset" indicates that all the sales data relating to the report data must be
zero (except non-resettable memory data). Because of this "Condition" requirement, the report data will
be protected from any inconsistencies of sales data entered in the period from a resetting of the report
to another resetting of the same report next time.
When Condition "Any time outside a sale" is attached:
It means that no condition is specified to a programming (setting) operation, and that the operation is
allowed any time outside a sale (but the cashier must be signed off if the Cashier Signing Method op-
tion is selected).
Before changing each setting described in the following pages, be sure to turn the Control Lock to the
SET position using the MA Key.
- 22 -
EO1-11126
MA-1350-1 SERIES