If The Roll Paper Jams Or Feeds Incorrectly; Removing And Storing Roll Paper - Epson 1280 Printer Basics Manual

If the Roll Paper Jams or Feeds Incorrectly

If the roll paper feeds incorrectly, do the following:
1. Press the z roll paper button for three seconds to rewind the paper. (You may
have to do this more than once to rewind the paper completely.)
If the paper is jammed and won't rewind, turn the printer off. Then cut the roll at
a point a few inches away from where it exits the printer. Make your cut as
straight as possible to avoid further feeding problems. Gently pull the roll
backward to rewind it, and then turn the printer on again.
2. After you rewind the paper, the b maintenance light comes on. Press the
b maintenance button to turn the light off.
3. Reload the paper, making sure the end is straight and not damaged. If necessary,
trim the end again before reloading.

Removing and Storing Roll Paper

When you finish a print job on roll paper, you can position the paper for another
print job or remove it from the printer. Follow these steps:
1. Press the z roll paper button. The printer
prints a small line on the roll paper to show you
where to cut it and feeds the paper forward.
2. If you want to continue printing on roll paper,
press the z roll paper button again; the paper
feeds back into the printer. Then send the next
print job; the paper will move into the correct
loading position before printing.
If you're finished printing on roll paper, follow
the rest of the steps to remove it.
3. Cut the roll paper on the side of the line facing away from the printer. Make your
cut as straight as possible to avoid feeding problems.
Roll paper button
Loading Paper
17