Checking The Machine Pulley Rotating Direction; Preparation Before Sewing; Needles And Threads; Installing The Needles - Brother DA-9270 Instruction Manual

4-7. Checking the machine pulley rotating direction

¡
Do not touch any of the moving parts or place any objects against the machine while sewing, as this may
result in personal injury or damage to the machine.
q

5. PREPARATION BEFORE SEWING

5-1. Needles and threads

The needle and threads to be used vary depending on sew-
ing conditions. Select the correct ones by referring to the
table below.
Needle
Upper thread
ORGAN TV 64
#11 spun yarn #80
#12
#14 spun yarn #60
#16 spun yarn #50

5-2. Installing the needles

¡
Turn off the power switch before installing the needle, otherwise the machine may operate if the treadle is
pressed by mistake, which could result in injury.
CAUTION
Thread
Lower thread
spun yarn #80
spun yarn #60
spun yarn #50
CAUTION
q
w
e
DA-9270
4. INSTALLATION
5. PREPARATION BEFORE SEWING
1. Insert the power cord plug into the wall outlet, and
then turn on the power switch.
2. Depress the treadle slightly and check that the ma-
chine pulley starts to turn in the direction of the ar-
q
row .
* If the direction of rotation is reversed, change the
direction of rotation to the correct direction while
referring to the instruction manual for the motor.
* For the first 3 - 4 days of use, run the machine at
500 rpm lower than the usual speed. This will help
contribute to a longer service life for the machine.
1. Turn the pulley until needle holder
highest position.
2. Loosen needle set screws
long grooved side facing front, insert them into needle
q
holder all the way, and fasten the needle with needle
w
set screws .
q
is raised to the
w e
, hold needles with their
8