Configuring Manually - Hitachi CPX809 - XGA LCD Projector Network Manual

3.4 Passcode connection (continued)

3.4.3 Configuring manually

After you input the Passcode (34), you are required to input the network setting
manually if you use any encryption code or your unique SSID or Subnet mask
except Class A/B/C. (32)
If you use the wired LAN, go to (40).
Wireless LAN
The required information depends on how you connect the projector and PC.
• Direct connection between the projector and PC (AdHoc mode)
• The projector connected to an access point by a LAN cable
• The projector connected to an access point by the wireless LAN
Direct connection between the projector and PC (AdHoc mode)
1) Enter the following information that is set in the projector. *1
SSID *2: wireless (example)
Encryption: WEP64bit (example)
Encryption key *3: ********** (example)
Subnet mask *4: 255.255.255.128
2) Click [Connect].
3) The wireless connection will be established.
Proceed to the item 3.6 Confirm the
connection to your destination. (50)
*1 To find the network setting on the projector, refer to the NOTE. (40)
*2 If you don't use the factory default SSID, you need to set your SSID by either
entering manually or selecting from the list of detected SSID.
*3 If you use an encryption, you need to set it. Contact the network administrator
to find the encryption key that is set in the projector.
The encryption key is always shown as " ********** ".
*4 If you use Subnet mask except Class A/B/C, please set it.
(example)
3. Using the Live Mode
37