Cleaning The Print Head - Epson Stylus Photo R300 Series User Manual

Cleaning the Print Head

If your printouts are unexpectedly light or faint, or dots or lines are missing from the image,
you may need to clean the print head. This unclogs the nozzles so they can deliver ink
properly. Print head cleaning uses ink, so clean it only if quality declines.
You can clean the print head either from the printer's control panel or using your printer
software. To clean using the printer software, the printer must be connected directly to your
computer (not over a network); see your on-screen Reference Guide for details.
Caution: When you don't turn on your printer for a long time, the print quality can
decline, so turn it on at least once a month to maintain good print quality.
Follow these steps to clean the print head from the printer's control panel:
1. Make sure the printer is turned on but not printing, and the red
If the red light is flashing or on, you may need to replace the ink cartridge; see page 89 for
details.
2. Press the
3. Use the
4. To begin cleaning, press
While cleaning, the printer makes noise and you see a progress bar on the control panel
display. Cleaning takes about 30 seconds.
Caution: Do not turn off the printer or interrupt the cleaning process.
5. When the cleaning is done, run a nozzle check to confirm the print head nozzles are
clean.
Make sure letter-size plain paper is loaded in the printer, then press
check pattern prints (see the next section for details).
6. If the pattern has gaps or missing dots, press
If the nozzle check pattern looks correct, press
88
Maintaining Your Printer
button to highlight
More Options
or button to highlight
.
OK
, then press
, then press
Head Cleaning
to clean the print head again.
Stop
to finish.
OK
b
error light is off.
.
OK
.
OK
. The nozzle
Stop