Loading Paper in the Sheet Feeder
Follow these steps to load paper.
Open the paper support, then slide out the
Lower the output tray and slide out the extension.
Slide the edge guide to the left.
Fan a stack of paper, then tap it on a flat surface to
even the edges.
Load the paper against the right side of the sheet
feeder, with the printable side up.
Place the stack of paper behind the tabs and make
sure it fits under the c mark inside the left edge
guide. Always load paper short edge first, even for
10 × 15 cm (4 × 6 in),
13 × 18 cm (5 × 7 in),
Slide the edge guide against the left edge guide of
the paper (but not too tightly).