Starting The Thermostat; Testing The Thermostat - GE RAK148P1 Owner's Manual & Installation Instructions

Starting the thermostat.

CAUTION!
the outdoor temperature is below 50 degrees. This can damage
your air conditioning system and cause personal injuries.
1. Move the Fan Auto/On
switch to the Auto position.
On position runs indoor
fan continuously.
2. Move the Function switch
to Cool or Heat, depending
on the season.

Testing the thermostat.

Once the thermostat is installed, it should be thoroughly tested.
CAUTION!
the outdoor temperature is below 50 degrees. This can damage
your air conditioning system and cause personal injuries.
Note: Before testing the thermostat, move the Fan Auto/On switch
to the Auto position.
Cool Test
1. Slide Function switch to Cool
position. Cool mode screen is
displayed.
2. Adjust set temperature so it is 5
degrees below room temperature.
3. Air conditioning should come on within a few seconds.
4. Adjust the set temperature so it is 2 degrees above the room
temperature and the A/C should turn off. Note: There is a 3
minute time delay and a 3 minute minimum run time for the
compressor when it turns on/off. (On some models, the fan
may also have a 3 minute minimum run time/off time delay.)
Do not use air conditioning when
AM
OFF
Time
Room Temperature
OFF Indicator
Do not use air conditioning when
COOL
AM
11