Rear Panel - Sony CDU948S User Manual

Rear Panel

1 1 Jumper block for SCSI bus 1
1 1
Specify assignment of the SCSI bus.
2 2 2 2 2 Terminators
The terminator resistors are inserted into the sockets. Remove the
resistors when the SCSI bus is to be terminated externally.
Note:
Some models are shipped without terminators.
When installing the terminators, orient them so that the GND pin
(the end marked with a dot) is toward the right side of the socket.
3 3 Power-in connector 3
3 3
Connect to the power supply of the host computer.
4 4 4 SCSI bus interface connector 4 4
Connect to a SCSI host adapter using a connecting cable.
5 5
5 5 5 Audio output connector
Outputs analog audio signals.
See page 14 for detail.
6 6 6 Frame ground tab
6 6
Connect to one of the host computer's ground cables when the
drive frame is not in direct contact with the computer.
Location and Function of Parts and Controls
7