Schedule - Digimerge Touch DH200 Series Instruction Manual

H.264 digital video recorder with touch sensitive control
Hide thumbs Also See for Touch DH200 Series:
Table of Contents

Advertisement

SCHEDULE

Daily has priority over a Weekly
NOTE:
schedule.
Figure 37.0 Schedule options
To set a recording schedule:
1. Select MODE1 (red), MODE2 (orange),
MODE3 (green), or MODE4 (blue) and
configure the following:
Figure 37.1 Mode tab options
• USE: Select ON/OFF. If OFF, the selected
camera(s) will not record.
• QUALITY: Select LOW, MIDDLE, HIGH,
SUPER, and ULTRA.
• RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.
• AUDIO: Select ON/OFF. Audio channels vary
by model.
• MOTION: Select ON/OFF
Figure 37.2 Daily schedule input
2. Select the CHART tab and select ALL,
SUN, MON, TUE, WED, THU, FRI, or SAT.
The Schedule sub-menu opens.
3. Enter BEGIN and END times, and select
the MODE for ten time slots and click OK.
4. Click APPLY and then OK to save your
settings and close the window.
NOTE: You must enable scheduled recording
directly on your system. DVR NetView will only
let you edit and configure the recording
schedule(s).
NOTE: For an example on setting a recording
schedule, see "Overnight Recording" on
page 26.
Remote Setup
63

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Touch dh200p series

Table of Contents