Table of Contents
Advertisement
MOLDING
CUTTING
Instructionsfor operating the Molding Head are con-
tained in a booklet furnished with the Molding Head.
The recommended molding head is listed under Recom-
mended Accessories in this manual.
Always use Molding
Insert listed under Recom-
mended Accessories.
When using the molding head, it wil! be necessary to
remove the Blade Guard and Spreader.
USE CAU-
TION.
USE MITER GAUGE, FENCE, FEATHER-
BOARDS, AND PUSH STICK, ETC., AS REQUIRED.
ALWAYS
REPLACE
THE
BLADE
GUARD
AND
SPREADER WHEN YOU ARE FINISHED MOLDING.
ADJUSTMENTS
WARNING:
FOR YOUR
OWN
SAFETY,
TURN
SWITCH "OFF" AND REMOVE PLUG FROM POWER
SOURCE
OUTLET
BEFORE
MAKING
ANY
ADJUSTMENTS.
BAR
i
LOCK
KNOB
\
"0"
STO
PIN
MITER
GAUGE
NOTE: The slots for the stop pin and the graduations
are manufactured
to very close tolerances
which
provide accuracy for average woodworking.
In some
cases where extreme
accuracy
is required,
when
making angle cuts, for example, make a trial cut and
then recheck it.
f necessary, the miter gauge head can be swiveled
slightly to compensate
for any inaccuracy.
1. Loosen the "knob" and pull "stop ;)in" OUT.
2. Swivel the head.,
position it at "0"...
push the
stop pin IN...
lock the handle.
3. The HEAD should be square with the Bar and the
pointer should point to "0". Readjust the pointer
if necessary.
4. If the head is not square with the bar. adjustments
are required.
A Loosen the "knob" (1) and the "two screws"
(2).
B Position the HEAD square with the BAR using
a combination
square.
C PUSH the STOP PIN into the slot in the head at
"0"
.. push the pin into the slot and twist it.
Lock the knob.
D. Recheck with the square. If the head is still not
square, loosen thescrews
(2) and readjust the
INDICATOR
BLOCK.
E. With the head square with the bar and the pm
pushed into the slot adjust the pointer (3) to
point to "0".
F. The miter gauge head must rest on top of the
bar without
being able to move up and down
•.. yet it must swivel freely
G. The swiveling
movement
of the head can be
adjusted by tightening
or loosening
the set-
screw (4)... using the 1/8 in. setscrew wrench.
SQUARE
IND|CAT(
BLOCK
I
t
V
1/8 IN. SETSCREw
WRENCH
2_
NOTE: The setscrew is located inside of the
head. To reach
it, swivel the head to 60
degrees and turn the miter gauge upside
down.
37
Hide quick links:
Advertisement
Table of Contents
