Craftsman 113.298720 Owner's Manual page 20

21. Loosen the two MOTOR CLAMP SCREWS on
each end of motor. Rotate the motor so that the
CAPACITOR COVER is on top.., tighten the
screws. The ventilation holes are now facing
downward which will help prevent sawdust from
entering motor.
CAPACITOR
COVER
\
\
VENTILATION
HOLES
\
MOTOR
CLAMP SCREW
(BOTH ENDS)
I
iNSTALLING BELT GUARD
1. Remove the belt and motor pulley.
2. Screws furnished with guard are "self threading"
• . screw them into holes in BELT GUARD
SUPPORT BRACKET, then remove them.
3. Position BELT GUARD SUPPORT BRACKET
and BELT GUARD SUPPORT as shown and
install the screws •,. make sure motor shaft is in
CENTER of hole in SUPPORT.
BELT GUARD
\
PIVOT
SCREW
_""J TWO HOLES CLOSEST
BELT GUARD (
SUPPORT BRACKET
SCREW
\
BELT GUARD SUPPORT
CENTERED
OPENING
/
4. Install three CLIPS (furnished with guard) 90 °
apart starting with one clip at the end of the
guard as shown.. , LONG END of clip facing BELTGUARD
AWAY from you.
LONG END
2O