Craftsman 113.298720 Owner's Manual page 13

8. Hold rod with one hand and with a 1/2 in. wrench
or pliers start screwing on ONE of the nuts only A
TURN OR TWO... screw on other nut the same
way.
9. Using TWO 1/2 in. wrenches or pliers tighten
both of the nuts.
10. Slide the bars so that screws are in the MIDDLE
of the slotted holes.
11, Position rip fence over miter gauge groove,
holding up the rear end while engaging front end
with bar lower fence onto table.
12. Raise blade all the way up.
13. Carefully move fence against blade.
14. Move front bar until "0" mark on rip scale is
approximately at tip of pointer.
15. Move FRONT bar upwards until fence is approxi-
mately 1/32 in. above table.., tighten screw at
left end of bar.
NOTE: Fold a piece of newspaper making 8
thicknesses and place between rip fence and
table to act as a spacer. This wil! hold the fence
off of the table approx. 1/32 in.
16. Adjust rear bar so that the fence is approximately
1/32 in. above table make sure it is square with
fence guide bar rod.., tighten screw at end of
bar.
8 THICKNESSES
OF PAPER
8 THICKNESSES
OF PAPER
17. Move fence to RIGHT edge of table.., make sure
t is approx. 1/32 in. above table at front and rear
and tighten screws.
13