How To Use Your Tractor; To Set Parking Brake; Stopping; Choke Control - Craftsman 917.270820 Owner's Manual

19.5 hp electric start 42" mower automatic
Hide thumbs Also See for 917.270820:
Table of Contents

Advertisement

he
o_per=_tiol_"of"_an'_=y'iractor
can res_u{t in
fore'_----_g-'n-0bjects_ih;own
intoth__
yes,whichcan result
in severe eye damage.
Always wear safety glasses
r eye shields while operating
your tractor or performing
any adjustments
or
pairs, We recommend
a wide vision safety mask over the spectacles,
or"
HOW' TO USE
YOUR
TRACTOR
Your tractor
is equipped
with an operator
presence
sensing switch,, When
engine is
running,
any attempt, by the operator
to
leave the seat without
first setting
the
parking
brake will shut off the engine.
TO SET PARKING
BRAKE
.
Depress
clutch/brake
pedal into full
"BRAKE"
position
and hold
o Place parking
brake lever in "EN-
GAGED"
position
and release
pressure
from clutch/brake
pedal.
Pedal should
remain in "BRAKE"
position.
Make sure
parking brake wili hold tractor
secure.
Attachment Clutch
Choke
Lever "Engaged"
Control
Position
Throttle
"Disengaged"
Control
',ilion
Parking Brake
"Brake"
led"
Positi_
_
Position
Motion
Pedal "Drive ....
Disengaged"
Control
Position
Position
Lever
STOPPING
MOWER
BLADES
-
,, To stop mower blades,
move attach-
ment clutch Lever to "DISENGAGED"
position_
GROUr,,1D DRIVE
_ ._
o To stop ground drive, depress
clutchlbrake
pedal into ful! "BRAKE"
po-
sition.
. Move motion control lever to neutral (N)
position°
IMPORTANT:
The motion control lever
does not return to neutral
(N) position
when lhe clutch/brake
pedal is depressed,
ENGINE -
,, Move throttle control to slow position.
NOTE:
Failure to move throttle
control to
slow position
and allowing
engine to idle
before stopping
may cause engine to
"bacldire"_
TUrn ignition key to "OFF" position and
remove key. Always remove key when
leaving tractorto
prevent unauthorized use.
o Never use choke to stop engine,
NOTE:
Under' certain conditions
when
tractor
is standing
idle with the engine run-
ning, hot engine exhaust
gases may
cause "browning"
of grass. To eliminate
this possibility,
always stop engine when
pping tractor
on grass areas..
CAUTION.
Always
stop tractor com.,
pletely, as described
above, before leaving
the operator's
position,
to empty grass
catcher,
etc
THROTTLE
CONTROL
Always
operate
engine at full throttle,
= Operating
engine at less than full throt-
tle reduces
the battery charging
rate,
.
Full throttle
offers the best bagging
and
mower performance.
CHOKE
CONTROL,
Use choke control whenever
you are start.,,
ing a cold engine.
Do not use to start a
warm engine
° To engage
choke control,
pull knob out.
Slowly push knob in to disengage°
TO MOVE
FORWARD
AND BACKWARD
The direction
and speed of movement
is
controlled
by the motion control lever,,
o Stall hactor with motion control lever in
neutra! (N) position,,
o Release
parking
brake and clutch/brake
pedal
o Slowly move motion control lever to
desired
position.
NOTE:
The effort to move the motion con-
trol lever well reduce after the first few
hours of use. This is normal.
TO ADJUST
MOWER
CUTTING
HEIGHT
The cutting
height is controlled
by turning
the height
adjustment
knob in desired
direction.
o Turn knob clockwise
(©) to raise cutting
height.
. Turn
knob
countercloclw_'ise
(©)to
lower ct'_tting height.
14

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ez3 917.270820

Table of Contents