Craftsman 917.374942 Owner's Manual page 19

22" multi-cut rotary lawn mower
Hide thumbs Also See for 917.374942:
Table of Contents

Advertisement

TROUBLESHOOTING
- See appropriate
section in manual
unless directed
PROBLEM
to a Sears Parts & Repair
Center.
CAUSE
Loss of power
Poor cut =
uneven
Excessive
vibration
Starter
rope
hard to pull
Grass catcher
not filling
(if so equipped)
Hard to push
.
2.
3.
4.
5.
6.
1.
2.
3.
.
2.
.
.
3.
4.
.
2.
3.
1.
2.
3.
4.
Loss of drive
or slowing
of
drive speed
Rear of mower housing or
blade dragging in grass.
Cutting too much grass.
Dirty air filter.
Buildup of grass, leaves,
and trash under mower.
Too much oil in engine.
Walking speed too fast.
Worn, bent or loose blade.
Wheel heights uneven.
Buildup of grass, leaves
and trash under mower.
Worn, bent or loose blade.
Bent engine crankshaft.
Engine flywheel brake is on
when control bar is released.
Bent engine crankshaft.
Blade adapter broken.
Blade dragging in grass.
Cutting
height
too low.
Lift on blade worn
off.
Catcher
not venting
air.
Grass is too high or wheel
height is too low.
Rear of mower housing or
blade dragging in grass.
Grass catcher too full.
Handle height position not
right for you.
1. Belt wear.
2. Belt off of pulley.
3. Drive cable worn or broken.
4. "Loose" drive control system.
CORRECTION
1. Raise cutting height.
2. Raise cutting height.
3. Clean/replace
air filter.
4. Clean underside of mower
housing.
5. Check oil level.
6. Cut at slower walking speed.
1. Replace blade. Tighten
blade bolt.
2. Set all wheels at same
height.
3. Clean underside of
mower housing.
1. Replace blade. Tighten
blade bolt.
2. Contact a Sears or other
qualified service center.
1. Depress control bar to
upper handle before
pulling the starter rope.
2. Contact a Sears or other
qualified service center.
3. Replace blade adapter.
4. Move lawn mower to cut
grass or to hard surface.
1. Raise cutting height.
2. Replace blade.
3. Clean grass catcher.
1. Raise cutting height.
2. Raise rear of mower housing
one (1) setting higher.
3. Empty grass catcher.
4. Adjust handle height to suit.
1. Check/replace
drive belt.
2. Check/reinstall
drive belt.
3. Replace drive cable.
4. Adjust drive control.
NEED
MORE
HELP?
You'll find the answer and more on managemyhome.com
= for free!
o Find this and all your other product manuals online.
o Get answers from our team of home experts.
o Get a personalized
maintenance
plan for your home.
o Find information and tools to help with home projects.
19
brought to you by Sears

Advertisement

Table of Contents
loading

Table of Contents