Craftsman 358.799230 Operator's Manual page 8

E_Gg_G POSSTION
Press the button and twist the lower
portion 180 ° into an edging position.
Button
EDGING
While edging allow the tip Ofthe line to
make contact. Do nef force the line.
The edge guard helps protect the unit
and keeps the unit from contacting the
ground. Take extra caution while edg-
ing as objectsCanbe thrown from the
trimmer line.
' _ WHEN TO PERFORM _.1
Before each use
....... Before eechuse :
Aftareach Us.e i
GENERAL RECOMM_DATIONS
Thewarrantyonthis unit d _;nct cov-
er
items that have be_ subjected to
operator abuse or neghgen.ca,To re-
ceive full value from the'warranty, the
operator must maintain unit as Instruct-
ed In this manual. Various adjustments
will need to be made periodicallyto
properlymaintain your unit.
CHECK FOR LOOS_ .....
FASTENERS AND PARTS
• Housing Screws
• Assist Handle Sc_
• Debris Shield
• Edge Guide
RSPL C .G S LiNS
CH_CK F OR _AMAG_D Or
wor_ PAR__
Refer replacement of damaged/worn
Paris t0 Your Se_ Service Centar,_
• Trigger Switch- EnsUre switch func-
tions properly by pressing and re-
leasing the trigger switch. Make sure
motor stops,
, Debris Shleld- Discontinue use of
unit if debds sPiieldis dmaged.
CLaNuNrr &I_SL=LS
= C!ean th_unit _!dg e. damp cloth
_th a mdd:_:let_rgen_.
o WIDe off Uhit with a €le_*drv cloth.
• Remove the _li_::fi_lypulling
u
• Clean ce of.h band
spool. .
= Replace with a pre-wound spoo!
(# 71-85837), or cut a length of 30
feet of .065" (1,6ram) diam., eter_.
Craftsman® Pro Trimmer hne._Useof
heavier lines could overloed the unit
and damage unit. Never use wire.
rope, stri_ e_._:-_,_'Chcanbreak off
and become _;i_an_gp_i_sinissile.
olnSert one*end bfthe_iabout 112
inch (1 i_) Int_ _i h_ole inside
: the spool_ " .
Wind the II-r_e.even!yaq_ _id bghtlyonto
the spool. Win_l_ip _i_i_on of the
arrow found o nff_:s_l, "
= Push the hne =nt_the _otch, _leaving
3 to 5 inches (7_:12 cm) Unwound,
8