Download Print this page

Advertisement

IMPORTANT:Yourtractor is
equipped
with a 12 volt system.
The other vehicle
must also be a 12 volt system.
Do not use
your tractor
battery
to start other vehicles.
TO ATTACH JUMPER
CABLES
-
1.
Connect
one end of the RED cable
to the POSITIVE
(+) terminal
of each
battery(A-B),
taking care not to short
against
tractor
chassis.
2.
Connect
one end of the BLACK
cable
to the NEGATIVE
(-) terminal
(C) of
fully charged
battery.
3.
Connect
the other end of the BLACK
cable
(D) to good chassis
ground,
away from fuel tank and battery.
TO REMOVE
CABLES,
REVERSE
ORDER
-
1.
BLACK
cable first from chassis
and
then from the fully charged
battery.
2.
RED cable last from both batteries.
Weak or Dead
Fully Charged
Battery
Battery
REPLACING
BATTERY
_IWARNING:
Do not short battery
terminals
by allowing
a wrench
or any
other object
to contact
both terminals
at
the same time. Before
connecting
battery,
remove
metal bracelets,
wristwatch
bands,
rings, etc.
Positive
terminal
must be connected
first to prevent
sparking
from accidental
grounding.
1. Lift seat pan to raised
position.
2.
Disconnect
BLACK
battery
cable first
then RED battery
cable and carefully
remove
battery
from tractor.
3.
Install new battery
with terminals
in
same position
as old battery.
4.
First connect
RED battery
cable to
positive
(+) terminal
with hex bolt and
keps nut as shown.
Tighten
securely.
Slide terminal
cover over terminal
5.
Connect
BLACK
grounding
cable
to
negative
(-) terminal
with remaining
hex bolt and keps nut. Tighten
securely.
. (_Negative
(Black)
Cable
Positive
(Red)
Cable
TO REPLACE
HEADLIGHT
BULB
1. Raise
hood.
2.
Remove
bulb holder from the hole in
the backside
of the grill.
3.
Replace
bulb in holder and install bulb
holder
securely
back into the hole in
the backside
of the grill.
4.
Close
hood.
INTERLOCKS
AND RELAYS
Loose
or damaged
wiring
may cause
your tractor
to run poorly, stop running,
or
prevent
it from starting.
• Check
wiring.
See electrical
wiring
diagram
in the Repair
Parts section.
TO REPLACE
FUSE
Replace
with 30 amp automotive-type
plug-in
fuse.
The fuse holder
is located
behind
the dash.
TO REMOVE
HOOD
AND GRILL
AS-
SEMBLY
1. Raise
hood.
2.
Unsnap
headlight
wire connector.
3.
Stand
in front of tractor.
Grasp
hood at
sides,
tilt toward
engine
and lift off of
tractor.
4.
When
replacing
hood,
be sure to re-
connect
the headlight
wire connector.
Headlight Wire
Connector
26

Advertisement

COMING SOON

   Related Manuals for Craftsman 917.276640

This manual also for:

917.276641

Comments to this Manuals

Symbols: 0
Latest comments: